The evolutionary successor to the VAR series—Tecnocooling Mistmatic. An automatic and flexible high-pressure pump for multi-zone adiabatic humidification or air cooling systems.
Its reliable and time-tested power unit consists of a brass-cast, triple-plunger, axial high-pressure pump and a three-phase asynchronous motor with forced-air cooling.
The new controller features an advanced Time 2.0 digital timer with adjustable cyclic operating time, daily, and weekly cycles. A MODBUS communication module is available upon request. A built-in hour meter alerts you when maintenance is required.
A 1.5 kW 400 V frequency controller adjusts the motor speed according to the flow rate of active loads. A relay and pressure transducer monitor automatic start and stop, stopping the pump in the event of a lack of water or a leak in the high-pressure line. The glycerin-damped pointer pressure gauge is located on the front panel. Powder-coated steel housing with IPX5 dust and moisture protection rating, power cord with grounded plug, ports for external signals, 10 mm PUSH-IN inlet and 3.8" PUSH-IN outlet fittings.
A distribution unit with solenoid valves or ball valves can be connected to the Mistmatic pump. When a valve or valve is opened, the Mistmatic pump will automatically increase pressure and decrease it when closed. Examples:
A multi-zone humidification system, where each valve receives a signal from a humidity sensor-based meter/controller. This could be a printing house with three rooms where the humidity in each room varies independently.
A multi-zone cooling system, where ball valves are used instead of valves, allows any number of valves to be opened or closed depending on the task. This could be a restaurant patio with umbrellas, where the cooling of each umbrella is controlled independently of the other umbrellas, and a single pump is used.
Dimensions, mm: 650 × 420 × 360. Weight, kg: 37.
Features
Fully automatic operation
Advanced digital timer Time 2.0
MODBUS protocol
Built-in 1.5 kW inverter for speed control, ensuring smooth starts and stops
Glycerin-damped pressure gauge
Brass triple-plunger pump
Steel pistons with ceramic coating
IPX5 dust and moisture protection
Rubber vibration mounts at the motor-frame junction and at the frame support point
Powder-coated steel frame and casing
Dry-running protection
Pressure regulator with safety valve
High-pressure switch for burst protection
Overheat protection
CE and EAC certified (DS TR CU)
Made in Italy, 2-year warranty
Models and features
TC308085
Flow rate: 1.0–5.0 l/min (60–300 l/h)
Power: 1.0 kW
Current: 5.0 A
Speed: 300–1450 rpm
Voltage: 220 V
0.15 mm nozzles: 16–105
0.20 mm nozzles: 10–60
Features: IPX5, Time, VAR
